Wisefab Supra/Soarer "Lock kit" Fram

Wisefab Supra/Soarer "Lock kit"

 

Passar: Toyota Supra MK4 / Soarer

 

Om du inte är hemma vad Wisefab "Lock kit" är så är det styrvinkel kit utvecklade rent för Drifting om du vill ha det värsta på marknaden så är detta nått för dig!

 

OBS! Ackerman kitet säljs separat som möjliggör ställbar ackerman plus eller minus.

Info på eng:

 

• 65 degrees of lock, parallel steering – both wheels turn the same angle. As an option, there  would be a possibility to buy Ackermann adjustment kit. You could tune your steering geometry either towards positive or negative Ackermann in just a few minutes even at trackside without messing up an alignment.

 

• Higher roll center (RC). Lowering the driftcar is a must to increase performance and handling, but this would mess up the original factory designed kinematics. It lowers the roll center and increases camber gain.  On Wisefab knuckle, both joints have lowered about 60mm, which brings the front RC up on lowered car, providing higher roll stiffness and letting to remove the front anti roll bar (sway bar) that is quite difficult to package with that high lock angles.

 

• Very good camber control and minimal bump steer with high steering angles. On drift cars the dynamic camber and bump steer is much more important than static. With our kinematics we have assured that the camber would provide very good front grip and bump steer is minimal at all the range of steering.

 

• Steering jacking control. During steering the car chassis is moving up and down – this is called jacking. Steering jacking is caused by combination of caster, KPI, trail and scrub. On road cars, this effect is used sometimes to balance the car or to help to turn in. During drifting, when steering angle is much bigger, jacking is also bigger, even with the same geometry and it could become a problem. We have changed the geometry that it doesn’t cause any handling issues.

 

• Consistent and predictable self-alignment torque. Caster is not the only important parameter to provide sufficient self-alignment torque especially at high lock. It’s the combination of different parameters to maintain consistent trail and self-alignment torque. With our setup the steering wheel turns always to the direction of movement and doesn’t get stuck at full lock.

 

• Adjustable spring and shock absorber motion ratio. The shock lower bracket has 3 attachment possibilities, which allows to change suspension stiffness and handling very quickly without changing the spring and messing up ride heights.

 

• Other components, packaging and clearance.

 

This kit assumes coilovers to have enough clearance.

 

Ride height is designed to be ~80mm from front subframe to ground

 

Dependent on rim width and ET, wider fenders or fender flares would be needed.

 

Inner wheel wells need to be slightly modified with tire diameter up to 635mm (215/45R17, 225/45R17, 235/40R17, 225/40R18 etc). Minimum rim diameter is 17”.

 

Recommended backspacing is ~135mm (7“ ET45; 8“ ET35; 9“ ET20). If ET is smaller, then wheels stay more outwards, if ET is bigger, then spacers need to be used.

 

The kit is designed and manufactured the way that after installation and toe adjustment it’s ready to use right away.

 

Happy drifting!